Yaskawa DriveWizard Plus User Manual download pdf (Page 176)

176

2) Set the pattern of operation for a Pattern Operation

a) Set the direction of rotation. Select the direction: END / FWD / REV / STP

b) Set the output frequency. Set the frequency reference within the allowable range (between

0.0 to 60.0 Hz).

c) Set the time for each operation. Time can be set from 0 to 3600 seconds. Specify the time the

drive should operate from when the Run command is given. This time will start over when a new

Run command is given.

3) Set the number of times the drive should execute the command.

To set the number of repeat times the command should be executed, first specify whether the

command should repeat a specified number of times or repeat indefinitely. Next, set the number of

times the pattern should be repeated. The total number of times can be set from 1 to 1000. This

value is enabled only when the “Specify number of times” setting is enabled.

4) Apply the settings that have been entered

Click “Apply” to check the contents that have been set. Drive performance will appear in a graph.

Once the pattern is complete and the drive stops, the following window will appear:

To accept the operation pattern that has been set until the drive reaches zero speed, click “Yes”. To

return to the Pattern Run window and start over again, click “No”.

5) Start operation

Clicking

will generate the following window:

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 197 198

No comments

Yaskawa DriveWizard Plus User Manual Page 176