14/12/94Warranty Standard products manufactured by the Company are warranted to be free from defects inworkmanship and material for a period of one
104/12/944OPERATIONRemote Display Controller Input (RDCI) and Get Numeric (GETN)The input channel number will be in decimal notation. The associatedi
114/12/944OPERATIONPower-upGeneralWithin the PAC program, the RDU and PLC initialization tables are used toconfigure the multiple source parameter exc
124/12/944OPERATIONSuggested PLC Ladder Strategy for GETN and RDCI PAC BlocksRung #LOAD_PLCLOAD_PLCLLLLLLTMRLOAD LATCH2 SECONDHANDSHAKETIMEOUTLOADUNLA
134/12/944OPERATIONPLC Gateway StatusSince the 2’s complement number put into the appropriate register will be aninteger, not an integer plus fraction
1Introduction1INTRODUCTION4/12/94I N T R O D U C T I O NS E T U PThe Square D Programmable Logic Controller Gateway (PLC Gateway) allowsany drive on t
34/12/942SETUPThe ARCNET node ID is set using the 8-position DIP switch, SW1. Enter thebinary node ID by choosing either a "0" or "1&q
44/12/942SETUPSOFTWARE3. 80188 Based CPU card (MagneTek part no. 46S03016-0010).Set serial port select to RS-232 by installing jumper plug on E1 fro
54/12/944OPERATIONOPERATION5/2/95The ARCNET node number, as set on the MicroTrac Network Interface cardand referenced by the various PAC blocks, will
6PAC output channels numbered 1 to 255 to the “interfaced” PLC registersnumbered from 3501 to 3755).The PLC gateway does not allow the mixing of data
74/12/944OPERATIONLogic (I/O) DataThe subchannel number will also be in decimal, and will directly correspond tothe bit number of the PLC input. Thus
84/12/944OPERATIONNumeric (I/O) DataNumeric (I/O)DataThe subchannel number also will be in decimal, and will directly correspond tothe bit number of t
94/12/944OPERATIONRemote Display Controller Input (RDCI) and Get Numeric (GETN)Numeric Inputs (NUMI) to a PAC schematic from a PLC is illustrated inFi
Comments to this Manuals