Yaskawa Z1000U User Manual download pdf (Page 44)

NOTICE: Use the hanging brackets on the top and hanging holes of the bottom cover when lifting models 2

0154F, 2

0192F, 4

0156F,

and 4

0180F.

2□0154A, 2□0192A, 2□0248,

4□0156A, 4□0180A, and 4□0216 to 4□0414

2□0154F, 2□0192F, 4 □0156F, and 4□0180F

Figure 2.4 Horizontal Suspension (Models 2o0154 to 2o0248 and 4o0156 to 4o0414)

Vertical Suspension of the Drive

Follow the procedure described below when suspending the drive with eye bolts or hanging brackets.

Models 2

0028 to 2

0130 and 4

0011 to 4

0124

WARNING! Crush Hazard. Use an adequate length of wire to ensure a 50° or wider suspension angle as illustrated in Figure 2.5. The

maximum allowable load of the eye bolts cannot be guaranteed when the drive is suspended with the wires at angles less than 50°. Failure

to comply may result in serious injury or death from falling equipment.

1. Pass wire through the holes of the two eye bolts.

Suspending angle:

50° or greater

Figure 2.5 Drive Suspension Using Wires and Eye Bolts

(Models 2o0028 to 2o0130 and 4o0011 to 4o0124)

2. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.

3. Lower the drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor, then slowly

begin lowering the drive again until the drive is placed correctly.

Models 2

0154 to 2

0248 and 4

0156 to 4

0414

2.2 Mechanical Installation

YASKAWA ELECTRIC TOEP C710636 10B Z1000U HVAC MATRIX Drive User Manual

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 377 378

No comments

Yaskawa Z1000U User Manual Page 44