YASKAWA Varispeed-606PC3 Instruction Manual download pdf (Page 163)

162

Communications/Multi-function Input Terminal Selection

(Setting: 18)

Operation can be changed from DeviceNet communications commands,

or from multi-function input terminal or Digital Operator commands.

RUN commands from communications and the frequency reference are

effective when the multi-function input terminal for this setting is

closed.

RUN commands in LOCAL/REMOTE mode and the frequency refer-

ence are effective when the terminal is open.

 Using the Multi-function Analog Inputs (n077, n078)

The input analog signal (0 to 10 V or 4 to 20 mA) for the CN2 terminal

of the JVOP-140 Digital Operator can be used as the main speed fre-

quency reference. Refer to the block diagram on page 185 for details on

the input signal.

When using the signal for the CN2 terminal of the JVOP-140

Digital Operator as a multi-function analog input, never use it

for the target value or the feedback value of PID control. (PID

control is disabled when n128 is set to 0.)

Multi-function Input Selection (n077)

Setting Description

0 Output frequency is not recorded during

HOLD.

1 When HOLD status is continued for 5 seconds

or longer, the output frequency during HOLD

is recorded and the Inverter restarts at the re-

corded frequency.

No. Name Unit Setting

Range

Factory

Setting

n077 Multi-function Input Selection - 0 to 4 0

NOTE

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 255 256

No comments

YASKAWA Varispeed-606PC3 Instruction Manual Page 163